⑤ Finally, fix the L-shaped bracket inside at each corner. It is useful for maintaining a certain gap between the frame and the interior frame while making the frame stronger. This gap becomes a frame interior point as if the frame is floating.Making interior frames 3D living room frames Making interior accessories DIY spring has come, so I thought I should replace interior frames all over the house, so I bought it. I… blog.naver.comTransformation of canvas frames~Chrome Nordic frames Making Nordic frames [Putting a chromium feel on canvas frames] Tomorrow… blog.naver.com⑥ Attach a hook that can be hung on the wall to the frame facing upward when hung.③ Apply woodworking adhesive to the contact surface and attach it. At this time, hold it with a corner clamp and fix it with a taka pin or a headless nail. It is recommended not to remove the clamp until the bond hardens.The thickness of the bracket must be carefully calculated in advance to cut the wood needed for the frame, so it fits tightly when inserting the canvas last time. Do not rush it in, but slowly. Since it is the only thing that holds the canvas, you must calculate the dimensions accurately from the beginning.① When making the frame, cut the part that meets at right angles at 45 degrees. There are also small plastic props that can be cut at 45 degrees, so search for them. Otherwise, you can request diagonal cutting when ordering from the wood cutting service site.④ When the frame is finished, I’ll paint it with oil stain. You can paint it according to your taste, but the purpose of making the frame is to paint it with stainless steel because it’s a solid wood frame. After you paint with stainless steel and dry it, apply a top coat or varnish. The reason for the transparent finish is that it protects the wood frame, so it stays for a long time.#CanvasFrame #WoodFrame #InteriorFrame #FrameMaking #FrameInterior #ShadowFrame② Make a temporary assembly outside the canvas frame to check if it is correct. The purpose is that there is a gap between the frame and the picture frame primarily with the thickness of the bracket. The reason comes out during the process.This is a picture of the canvas frame on the tether with a wooden frame. Doesn’t it feel much more luxurious than ordinary wood frames? Then I’ll show you the process of making a frame. Four wood sticks cut about 2~4cm wider than the thickness of the picture frame and 3mm longer than each length of the frame size. (The size of the wood varies depending on the frame size.) You need wood adhesive, corner lamp (selected part), screwdriver or wireless drill, oil stain, L-shaped bracket black, tan nail or woodworking tacker, hammer, angle cutting frame, saw, etc., but you can cope with the situation.Personally, I prefer canvas frames to aluminum frames. After removing the picture frames that had been hung for many years, it felt empty, so the hardwood frames caught my eye. I was looking for an interior frame that I liked, and I saw the process of reforming the hardwood frame into the existing canvas frame, so I want to share it with you, so I’m going to upload the process of making it. It would be good to change what I’ve seen for a long time and decorate it with a new frame interior. I’m looking hard because I think it would be more cool if the size was larger. I’m going to reform it into a hardwood frame as soon as I order and receive it.
